To open the meter readings form click on the Meter button on the WAS main form. The Meter readings form is used to capture all the measured volumes of water by every user.  Two meters can be used, meter A and meter B.  The difference between the beginning and end meter readings multiplied by a meter factor converts the meter reading to cubic meters. This volume is calculated automatically. When new meter readings are inserted, the meter factor (K1 & K2) for that specific meter is retrieved automatically. These factors are captured on the Meter factors form, which is opened using the button on the Meter readings form. Modification of meter factors will not affect existing meter readings.  If both meters A and B are used, the average volume is calculated. The bottom area of the form displays the quota, extra, surplus and flexi water balances of the current record as well as the total volume of all readings displayed.  A negative water balance is displayed in red.  The meter readings form will not accept non-existent users and invalid week numbers will also be rejected. The name, surname and address of the current user are displayed on the information line below the menu. Insert a new meter reading. Edit an existing meter reading. Delete the current meter reading. Password = Delete. Import meter readings from a *.csv file that was created using the Export button. Export meter readings to a *.csv file. Opens the meter factors form which is used to capture the K1 and K2 meter factors. Opens the cut-off list form. Generates a list of User id’s of meters that have not been captured in the current week.  The week value in the To week box is used. Opens the water transfers form which is used to capture water transfer volumes between users. Filters which are used to display the meter readings according to the various filter settings.  If a specific filter is set to *ALL* it will have no effect on the data displayed. Displays the Quota, Extra, Surplus and Flexi volumes of the current user. Displays the Total volume depending on the filter settings. Lookup button (A end - A begin) x K1 = Total A (B end - B begin) x K2 = Total B if Total B > 0 then   Total = (Total A + Total B)/2 else   Total = Total A